The tag printers print to very small paper. Therefore, The Edge allows you to adjust printer settings to ensure proper printing on the tag.
Center Adjustment
|
Allows you to adjust the center space between ends of the dumbbell tag.
|
Left Edge Adjustment
|
Allows you to adjust the left edge of the label. Bigger is more to the right.
|
Number of Retries to Open Port
|
The number of times to retry opening the printer port before showing an error.
|
Port Number
|
The tag printer port, e.g., LPT1.
|
Special Strings to Begin Batch Print
|
Special strings to send before a batch of tags. Not supported by all tag printer models. Might override other settings.
|
Special Strings to End Batch Print
|
Special strings to send at the end of a printer batch. Not supported by all tag printer models.
|
Special Strings to Send on Individual Tag Print
|
Special strings to send before each tag. Not supported by all tag printer models.
|
Tag DPI
|
The dots-per-inch capability of tag printer 1.
|
Tag Printer Burn Settings
|
This allows you to adjust the burn setting. Higher is darker. Not all printer types allow this.
|
Tag Printer Make & Model
|
The make and model of the tag printer, e.g., Eltron_2742.
|
Tag Sensor Mode
|
The method by which the tag printer senses the start of the label.
|
Tag Stop Position
|
Millimeters to advance the tag printer after printing, to be pulled back before the next tag begins. Applies to Zip Tape only.
|
Top Edge Adjustment
|
Allows you to adjust the space to the top.
|