There is no software to install for this scanner. However, it does require physical programing to work properly with The Edge. This programming is accomplished by scanning the specific programming barcodes provided below. Scan each barcode once in the order they appear. If you make a mistake, start over from the beginning.
If you purchased your scanner for use with another software system or just from another vendor, you will need to program the scanner for use with The Edge. Reprogramming a scanner that was purchased to work with a different software system may cause you to lose reading functionality in the former application. Therefore, you should program your scanner for use with The Edge when you are prepared to transition to The Edge as your primary application.
We recommend that you retain this document for your records. It can be used at any time to re-program the scanner and should be your first troubleshooting step should you run into trouble in the future.
If you have difficulty scanning the barcodes, try printing them from a different printer. Be sure Fit to Page is not enabled and it is printing with 100% scale.
Programming Barcodes
Scan the following barcodes in the order presented to program the scanner. If you make a mistake, start again from the first barcode.
For the complete Scanner Programming Codes printable PDF, please click HERE.